The Janitrol Gas Furnace is a high-efficiency heating system designed for residential use, featuring advanced combustion technology, multiple safety controls, energy-efficient operation, and reliable performance. Below are key sections covering safety guidelines, installation procedures, operation instructions, maintenance requirements, troubleshooting, and technical specifications.
Critical safety warnings and precautions for proper furnace operation.
| Warning | Description |
|---|---|
| Carbon Monoxide Hazard | Ensure proper ventilation and regular inspection of flue pipes |
| Gas Leaks | If gas odor detected, shut off gas supply immediately and contact professional |
| Electrical Safety | Disconnect power before servicing any components |
| High Temperature Surfaces | Keep flammable materials away from furnace cabinet |
| Professional Installation | Only qualified technicians should install or repair this unit |
Proper installation procedures for safe and efficient operation.
WARNING! Improper installation can cause fire, explosion, or carbon monoxide poisoning. Always use licensed professionals.
How to properly operate your Janitrol Gas Furnace.
CAUTION! Never attempt to adjust gas pressure or flame settings without proper training.
Understanding furnace controls and adjustment settings.
Main Controls: Power switch, Gas valve, Ignition control module, Limit switches, Pressure switches.
Operating Modes: HEAT, OFF, FAN ON. Diagnostic Lights: LED status indicators for troubleshooting. Adjustment Settings: Gas pressure (factory set), Fan speed settings, Temperature rise verification.
Regular maintenance schedule for optimal performance and safety.
Tip: Keep area around furnace clean and free of debris for proper airflow.
Common issues and basic troubleshooting steps.
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Furnace won't start | Power outage, tripped breaker, thermostat issue | Check power source, reset breaker, verify thermostat settings |
| No heat | Pilot light out, gas valve closed, dirty filter | Relight pilot, open gas valve, replace air filter |
| Short cycling | Dirty filter, blocked vents, faulty limit switch | Clean/replace filter, clear obstructions, call technician |
| Unusual noises | Loose components, airflow issues, motor problems | Tighten access panels, check ductwork, professional service |
| Pilot won't stay lit | Thermocouple issues, gas pressure problems | Clean/replace thermocouple, check gas supply |
Diagnostic flash codes for advanced troubleshooting.
| Flash Pattern | Description | Action Required |
|---|---|---|
| 1 Flash | Ignition lockout | Check gas supply and ignition system |
| 2 Flashes | Pressure switch fault | Inspect vent system and pressure switch |
| 3 Flashes | Limit switch open | Check airflow and filter; reset if needed |
| 4 Flashes | Rollout switch open | Immediate professional service required |
| 5 Flashes | Flame sensed when off | Gas valve or control board issue |
Manufacturer warranty coverage details.
Note: Warranty registration required within 60 days of installation.
For technical support, service, or warranty claims.
Janitrol Customer Service: 1-800-123-4567
Technical Support: 1-800-765-4321
Website: www.janitrol.com
Email: [email protected]
Emergency Service: Contact local authorized Janitrol dealer for immediate assistance.