Olsen Oil Furnace Manual

The Olsen Oil Furnace is a high-efficiency heating system designed for residential and light commercial use. This manual covers the Olsen series oil-fired furnaces with features including electronic ignition, multi-speed blower control, safety shut-off systems, and energy-efficient operation. Below are key sections for safety, installation, operation, maintenance, and troubleshooting.

1. Safety Precautions 2. Installation Instructions 3. Operating Instructions 4. Technical Specifications 5. Control Panel Overview 6. Maintenance Procedures 7. Troubleshooting Guide 8. Parts List 9. Warranty Information

Safety Precautions

Important safety information for proper furnace operation and maintenance.

Hazard	Precaution
Fire Hazard	Keep combustible materials at least 3 feet from furnace
Carbon Monoxide	Ensure proper ventilation and install CO detectors
Electrical Shock	Disconnect power before servicing
Burns	Allow furnace to cool before maintenance
Oil Spills	Clean immediately and dispose properly

Installation Instructions

Proper installation procedures for Olsen Oil Furnace.

Location: Install in well-ventilated area with adequate clearance.
Venting: Connect to approved chimney or vent system.
Oil Supply: Install oil tank and fuel line with proper filtration.
Electrical: Connect to dedicated 120V circuit with proper grounding.
Thermostat: Install compatible thermostat following wiring diagram.

WARNING! Installation must be performed by qualified technician only. Improper installation can cause fire or carbon monoxide poisoning.

Operating Instructions

How to operate your Olsen Oil Furnace safely and efficiently.

Startup: Set thermostat to desired temperature; furnace will ignite automatically.
Normal Operation: Monitor for consistent heat output and quiet operation.
Shutdown: Use thermostat to lower temperature; furnace will cycle off.
Seasonal Startup: Have qualified technician perform annual startup inspection.

CAUTION! Never attempt to manually start furnace if it fails to ignite automatically.

Technical Specifications

Model Series: Olsen OF-80 through OF-150
Heating Capacity: 80,000 - 150,000 BTU/hr
Fuel Type: No. 2 Heating Oil
Efficiency: 85% AFUE
Electrical: 120V, 60Hz, 5-8 Amps
Blower Motor: Multi-speed, 1/3 HP
Nozzle Size: 0.75 - 1.25 GPH
Weight: 180-250 lbs

Control Panel Overview

Main controls and indicators on the furnace control panel.

Primary Controls: POWER switch, RESET button, SERVICE indicator light, THERMOSTAT terminals.

Operation: Green light indicates normal operation. Red light indicates service required. Reset button for manual restart after safety shutdown. Power switch for complete system shutdown.

Maintenance Procedures

Regular maintenance schedule and procedures.

Monthly: Check air filters; clean or replace as needed.
Seasonal: Clean heat exchanger and combustion chamber.
Annual: Professional inspection including nozzle replacement, electrode adjustment, pump pressure check.
Biannual: Chimney inspection and cleaning.

Tip: Keep maintenance log with dates and services performed.

Troubleshooting Guide

Symptom	Possible Cause	Corrective Action
No heat	Power outage, thermostat setting, safety lockout	Check power supply, verify thermostat setting, press reset button
Insufficient heat	Dirty filter, nozzle clog, low fuel	Replace filter, clean nozzle, check fuel level
Furnace cycles on/off frequently	Overheating, airflow restriction	Check airflow, clean heat exchanger
Unusual noises	Motor bearings, loose components	Lubricate motor, tighten mounting bolts
Oil odor	Leaks, incomplete combustion	Inspect for leaks, check combustion efficiency

Reset Procedure: Press reset button once; wait 5 minutes before second attempt.

Parts List

Common replacement parts for Olsen Oil Furnace.

Oil Burner Nozzle: Part #ON-100 series
Ignition Electrodes: Part #IE-200
Fuel Pump: Part #FP-300
Air Filters: Part #AF-400 (16x25x1)
Blower Motor: Part #BM-500
Control Transformer: Part #CT-600

Warranty Information

Olsen Oil Furnace comes with limited warranty coverage.

Heat Exchanger: 20-year limited warranty. Parts: 5-year limited warranty. Labor: 1-year from installation date. Warranty registration required within 90 days of installation. For warranty claims, contact authorized Olsen service provider with proof of purchase and installation date.